A question about wheel hubs

[Perry Sims]

I am building a land sailer using two wheels from a Honda 600, the four bolt pattern, which I assume is the same for both designs. Can anyone tell me of a source for hubs and bearings which are compatible with these wheels?  Essentially, I'm using the wheels as though on a trailer. ie: free wheeling, and non-steering. I'd prefer a spindle with its own attachment system, or which can be welded to a mounting plate.  Thanks in advance for any information. XXX-XXX-XXXX  USA
Perry Sims
Sims Inspection Service
XXX-XXX-XXXX
XXX-XXX-XXXX Fax
sims-inspect@...

[kris c]

i would find someone that has an extra rear axle, the brake drum bolts onto the axle that has the bearing and wheel studs on it. The front ones would probably be harder to use since the axle spline has to be in the bearing to hold the hub to the knuckle.
Perry Sims wrote:

> I am building a land sailer using two wheels from a Honda 600, the four bolt pattern, which I assume is the same for both designs. Can anyone tell me of a source for hubs and bearings which are compatible with these wheels?
> Essentially, I'm using the wheels as though on a trailer. ie: free wheeling, and non-steering. I'd prefer a spindle with its own attachment system, or which can be welded to a mounting plate.  Thanks in advance for any information. XXX-XXX-XXXX  USA
> Perry Sims
> Sims Inspection Service
> XXX-XXX-XXXX
> XXX-XXX-XXXX Fax
> sims-inspect@ sbcglobal. net
Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls.
Great rates starting at 1�/min.