All,
Bruce D is right, the stopper pull on a bathroom sink will work. But recently I found that they are no longer coming as single items at the local Home Depot. But they are chrome (until you cut them to fit), and brass too. I even got the spring to work buy drilling a hole in it and they stay in place.
But if your looking for one close to original, go for the other one.
The originals are very hard to come by.
Bill
> -----Original Message-----
> From:
> 2cylinderhondas@yahoogroups.com [mailto:2cylinderhondas@yahoogroups.com] > On > Behalf Of > Bruce Dewing > Sent:
> Monday, February 15, 2010 5:37
> PM
> To:
> 2cylinderhondas@yahoogroups.com
> Subject:
> Re:
> [2cylinderhondas] plastic rod for the gas door on the an600 > sedan
> If looks isn't an issue, try a 16p nail and some electrical tape.
> IIRC, Bill C. Reccommends the rod that raises/lowers the sink > stopper.
> Bruce D.
> Santa
> Sent from myself
> On Feb 15, 2010, at 11:54 AM, John Jordan shakeyleg77@ yahoo.com
> wrote:
> > I installed a new plastic rod and spring at the
> > cost of $35.00 ,only to have it broken, when someone tried to steal > > gas . I ordered a new one ,and used it for a template at the machine > > shop , where two were made out of aluminum to reduce any sparks > > . the cost was $100.00 ,the cost of two plastic would have been > > $70.00+ shipping. if any one is interested,contact me at > > shakeyleg77@ > > yahoo.com > > the machine shop > > is Sadlin Enterprise address 150 robin dr. livingston, texas > > 77351 XXX-XXX-XXXX XXX-XXX-XXXX or e > > mail > > tsandlin@eastex. net