Hello All,
Does anyone have the picture or info about the Venolia Big Bore kit that used to be in the
group photos section? Any help would be appreciated.
Thanks,
Bruce
Venolia Big Bore Pistons
Re: Venolia Big Bore Pistons
I had that photo posted on the welcome page. I also have a set of
Venolias with cylinders ready to go. They may need rings or wrist
pins, I can't remember. But will look later and let you know *off
group*. Will sell them for $150/complete with cyls + shipping.
Miles
XXX-XXX-XXXX (California)
Venolias with cylinders ready to go. They may need rings or wrist
pins, I can't remember. But will look later and let you know *off
group*. Will sell them for $150/complete with cyls + shipping.
Miles
XXX-XXX-XXXX (California)
I need to ask a stupid question:
I would like to know if it is possible to purchase two loaded lower control
arm assemblies? Or if im am going to have to have them rebuilt?
Some back ground on me. I am the guy from Marin county emailed you a couple
of times to see the status of your shop in Felton. I have had some Beemer
guys look at the car and they think this might be the cause of the rattle.
They also think that it could have happend in transportation from North
Carolina.
Link
arm assemblies? Or if im am going to have to have them rebuilt?
Some back ground on me. I am the guy from Marin county emailed you a couple
of times to see the status of your shop in Felton. I have had some Beemer
guys look at the car and they think this might be the cause of the rattle.
They also think that it could have happend in transportation from North
Carolina.
Link