Name that part 2

[riceburner006]

I would sy that it's a end assembly for a sedan! riceburner006

[riceburner006]

--- In anzhonda600owners@yahoogroups.com, "riceburner006"
wrote:

> I would sy that it's a end assembly for a sedan! riceburner

Oh! I finally read all the instructions! The top one is a end assembly
for sedan-bottom picture shows a coupe end!! briceburner006

[dealadayray]

Not there yet...

[riceburner006]

--- In anzhonda600owners@yahoogroups.com, "william colford"
wrote:

> Not there yet...
> -----Original Message-----
> From:
anzhonda600owners@yahoogroups.com
> [mailto:
anzhonda600owners@yahoogroups.com
]On Behalf Of riceburner006
> Sent: Monday, April 25, 2005 11:02 PM
> To:
anzhonda600owners@yahoogroups.com
> Subject: [anzhonda600owners] Re: Name that part 2
> --- In
anzhonda600owners@yahoogroups.com
, "riceburner006"
> wrote:
> > I would sy that it's a end assembly for a sedan! riceburner
> Oh! I finally read all the instructions! The top one is a end assembly
> for sedan-bottom picture shows a coupe end!! briceburner006
> OK!! Is it vice versa?

[dealadayray]

The correct answer for the second question is that the shorter of the two
Steering Rack end assemblies is for the Coupe, the width of the Coupe is
less than that of the Sedan so it uses the shorter of the two ends. The
length of the Coupe's shaft is 1/4 inch shorter than the Sedan.
Important issues for the rack end assemblies is the ball ends. However
the Lock washer is the most critical of the components when renewing the
rack.
Watch for the next item up on "Name that part".
Bill