Oh my two cars, one is getting parted out, two is getting a full
restoration.
I pulled the motor from one today by myself, as I used to jacks at
the same time with 4x4 one each one. AS I dropped it, I lowered the
back jack first and I was able to clear the front sheet metal. When
it was about 10 inches off the ground, it tipped and knocked over and
sat on both jacks. I dragged it onto a furniture dolly with an old
cabinet door on it for support.
I am stripping the car and I suppose I will be selling what I dont
need for car 2.
My method worked fine for pulling it, but reseating one will require
some better plan that that one.
Pulled the motor
Re: Pulled the motor
The N360 engine fits out the top if you remove the carb, fan and
steering rack then lift from exhaust studs. Has anybody tried that
with the 600? Greg
steering rack then lift from exhaust studs. Has anybody tried that
with the 600? Greg