Mike Conner sells rebuilt ones, I wouldn't take the chance of letting a wheel come off at 70 on the freeway. If your tough on bucks, I am sure there is some one in the group close to you that has a used one.
Where are you located?
Bill
> -----Original Message-----
> From:
> Michael Karner
> [mailto:mk600groups@...]
> Sent:
> Monday, March 21, 2005 5:20
> PM
> To:
> 2cylinderhondas@yahoogroups.com
> Subject:
> [2cylinderhondas] Driveshaft thread pitch?
> The driveshaft threads on one of my coupe driveshafts is stripped > (luckily the splines are still good). No one nearby rents metric dies > that large (22mm). Before I purchase a die, can anyone confirm the > thread pitch? It looks like 1.5, but could be 1.25 or other? I > don't have a thread gauge and don't trust my ability to accurately count > threads.
> Also, has anyone done this successfully before? I wonder if recut > threads will hold 150 ft/lbs torque without stripping again. If I need > to pull them for further machining, is there a generic/rental hub > puller you've used in place of the Honda special driveshaft puller > tool?
> Anyone have an extra castle nut with good threads, or a source to buy one > from?
> Hoping to resurrect this little beast from early retirement 20 years > ago. Any help greatly appreciated.
> Thanks.
> -MK
> Do you Yahoo!?
> Yahoo! Small Business -
> Try
> our new resources site!