Re: [2cylinderhondas] Re: Gas filler door latch

Archived posts from the ANZ Honda 600 Owners Yahoo Group
Post Reply
Lyle
Posts: 41
Joined: Wed Mar 23, 2011 1:15 pm

Re: [2cylinderhondas] Re: Gas filler door latch

Post by Lyle »

I have used both, and finally found that the chrome pull for the bath room
sink drain plug looked and worked the best. The one I used had a chrome
knob at the top, is made of brass and chromed. I drilled a hole in it about
a 1/2 inch on the inside of the gas filler tube area and fitted a spring
over the end and pushed the end through the hole on the shaft. I think it
was a buck or two at Home Depot.
Bill
Post Reply