Hi Bruce, yes, your answer is the correct one.
Most of these clamps have been lost or bent beyond serviceable limits. But
with the proper equipment they can be fabricated with wire a bit heavier
than a coat hanger.
Bill
I will post the next picture in a while, maybe tomorrow. So keep looking.
Re: [anzhonda600owners] Name the part
-
dealadayray
- Posts: 1
- Joined: Sun Aug 18, 2002 12:08 am
Re: [anzhonda600owners] Name the part
OK, Happy Memorial day to all.
The next picture up on the anzhonda600owners yahoo group home page will have
a number of parts shown. All the parts need to be identified to their
lowest assembly item to be correct. Here is a hint, there are 16 parts in
the picture.
Specific instructions:
Each part still needs what it is, by part number and vehicle (Sedan or
Coupe) it belongs to. All the parts are specific to Honda and are listed in
their parts books.
So sharpen your pencils and look this stuff up.
If your not a member of the anzhonda600owners group then you will need to
join to see the picture and play along.
Bill
The next picture up on the anzhonda600owners yahoo group home page will have
a number of parts shown. All the parts need to be identified to their
lowest assembly item to be correct. Here is a hint, there are 16 parts in
the picture.
Specific instructions:
Each part still needs what it is, by part number and vehicle (Sedan or
Coupe) it belongs to. All the parts are specific to Honda and are listed in
their parts books.
So sharpen your pencils and look this stuff up.
If your not a member of the anzhonda600owners group then you will need to
join to see the picture and play along.
Bill